HONTO DENKI GEAR MOTOR CO., LTD
 
  About Electromagnetic Brake Motor  
 
     
 


Still on brake when motor is off-power
◎ Output From 6W to 120w
◎ Motor still in torque when off power    
Speed control type motor is available
◎ Still-on-brake system is approximately at 0.3Kgcm~5Kgcm  

Standard Electromagnetic Brake Motor type
 Item
Specifications
Insulation resistance
Use a DC500V high resistance gauge to measure the coil of motor and it's a outer shell when motor running in normal temperature and normal humidity, its value should be above 100MΩ .
Insulation pressure endurance
Apply 60Hz, 1.5kV at the coil of motor and it's a outer shell for one minute without and extraordinary phenomenon when motor running in normal temperature and normal humidity.
Temperature arise
Install two reduction gears or radiation plate of the same class at the motor. After rated running, test the coil by resistance method. Its value should be less than 80°C.
Insulation Class
Class B (130°C)
Overheat protection
Over heat shut down system.
Environment temperature
-10°C~+50°C
Humid around the environment
Below 85% (No frosting happen)
▲ Over heat shut down system is not a standard device, please notice before order.
 
     
2012 © HONTO DENKI GEAR MOTOR CO., LTD ‧ Address:No.3, Gong 2nd Rd., Linkou District, New Taipei City 244, Taiwan
‧Tel:886-2-26010699 ‧Fax:886-2-26010959 ‧E-mail:honto.denki@msa.hinet.net