HONTO DENKI GEAR MOTOR CO., LTD
 
   About  IK Induction Motor  
     
 



Runing in only one direction
◎Output From 6W to 150W
◎Single Phase and Three Phase are available 
Four-pole standard and high speed bipolar type are vailable
◎Both lead wire and terminal box connection is available  


Standard  IK Induction Motor Type
  Item
Specifications
Insulation resistance
Use a DC500V high resistance gauge to measure the coil of motor and it's a outer shell when motor running in normal temperature and normal humidity, its value should be above 100MΩ
Insulation pressure endurance
Apply 60Hz, 1.5kV at the coil of motor and it's a outer shell for one minute without and extraordinary phenomenon when motor running in normal temperature and normal humidity.
Temperature arise
Install two reduction gears or radiation plate of the same class at the motor. After rated running, test the coil by resistance method. Its value should be less than 80°C.
Insulation Class
Class B (130°C)
Overheat protection
Over heat shut down system.
Environment temperature
-10°C~+50°C
Humid around the environment
Below 85% (No frosting happen)
▲If extra protection with overheat is needed please specify when ordering.
 
     
2012 © HONTO DENKI GEAR MOTOR CO., LTD ‧ Address:No.3, Gong 2nd Rd., Linkou District, New Taipei City 244, Taiwan
‧Tel:886-2-26010699 ‧Fax:886-2-26010959 ‧E-mail:honto.denki@msa.hinet.net